The Down Range Forum
Member Section => Down Range Cafe => Topic started by: hodman on December 20, 2007, 01:59:26 PM
-
I just got a slightly used gun for ICORE. I can't decide to put an optic on or not?
Any thoughts
Also I have am debating moon clips or not I have been told there is major issues with brass ect?
BTW the gun is a 327 (I got it for 650.00)
(http://www.smith-wesson.com/wcsstore/SmWesson/upload/images/firearms/170269_large.jpg)
(http://www.smith-wesson.com/wcsstore/SmWesson/upload/images/firearms/170269a_lrg.jpg)
Thanks
Jon
-
Being a Performance Center gun, does'nt that put you into Open class? If so, I'd go for the optics. Moon clips are the way to fly, but buy lots of them, the 8 shot ones bend and break easily, usually as your loading on the run and you or the range officer steps on them or kicks them. I use .38 short colt brass in My 627PC, with 130 grn FMJ'S, the moon clip grabs them very well, no wiggle.
Nice purchase, I'm looking for a TRR8.
-
would the muzzle blast damage the light? No question about the optic I would go for it! 8) You got a greeat deal!
-
Being a Performance Center gun, does'nt that put you into Open class? If so, I'd go for the optics. Moon clips are the way to fly, but buy lots of them, the 8 shot ones bend and break easily, usually as your loading on the run and you or the range officer steps on them or kicks them. I use .38 short colt brass in My 627PC, with 130 grn FMJ'S, the moon clip grabs them very well, no wiggle.
Nice purchase, I'm looking for a TRR8.
I was told as long as it did not have an optic you could shoot limited. I have several friends that are using 38 short colt. I spoke with Jerry M and he said that short range this would work, but at 50 yard the case was too short. I was told you could use 38 spc but only use starline brass. I just need to get to the range and work it out.
Thanks for your help
Jon
-
would the muzzle blast damage the light? No question about the optic I would go for it! 8) You got a greeat deal!
No damage but burns are common.
-
Are these 327TRR8s ready for moonclips from the factory or do the cylinders need to be machined?
-
They are ready to go from the factory ;D