The Down Range Forum
Member Section => Tactical Rifle & Carbine => Topic started by: gunman42782 on November 10, 2007, 02:59:05 PM
-
Well, I got my gas block changed, the Holosight on and the BUIS. Almost. The BUIS I bought from Sportsmans Guide for about $50 each. (I know, I am cheap. It about killed me to pay that much!) These sights are made by ProMag, so probably made in flipping China, although I can't find a mark on them anywhere as to country of origin. The rear sights mounting screw was actually bent when I got it and is not long enough to mount it, so it is just laying on the flat top in the picture, but I couldn't wait to show it off. SG is sending me another screw. I have not sighted the Holosight in yet as I figured I would wait until I get the screw and sight them both in at the same time. (That and it is deer season here.) Anyway, here is the not so great pictues. I will take some of the other side when I get my screw and the sight will stay on!!!!
With sights down:
(http://i94.photobucket.com/albums/l96/gunman42782/100_1681.jpg)
With sights up:
(http://i94.photobucket.com/albums/l96/gunman42782/100_1680.jpg)
-
Nice lookin' rifle... ;D
Is that a 20" barrel?
-
Nice lookin' rifle... ;D
Is that a 20" barrel?
No, that is a 16 incher.
-
;) Nice looking!
-
Very nice, What sling are you going with?
I'm with you about AR bit's and pieces - found my ARM 40L for $80 and it about killed me to pay that much!
-
Very nice, What sling are you going with?
I'm with you about AR bit's and pieces - found my ARM 40L for $80 and it about killed me to pay that much!
I just ordered this one:
http://www.bravocompanyusa.com/Specter-Single-Point-Tactical-Sling-MOUT-p/sling%20mout%20-%20black.htm
-
cool gun :)