The Down Range Forum
Member Section => Down Range Cafe => Topic started by: tombogan03884 on August 01, 2020, 05:00:45 PM
-
What is the "state of the art" nowadays ?
Especially metal printing , what can they do ?
2nd, What are these "ghost guns" I've seen advertised ?
What does the little milling machine require ?
Electricity only ?
Or do you need a compressor as well ?
-
What is the "state of the art" nowadays ?
Especially metal printing , what can they do ?
2nd, What are these "ghost guns" I've seen advertised ?
What does the little milling machine require ?
Electricity only ?
Or do you need a compressor as well ?
anything you can cast you can 3d print, but with eternal details you could never cast. In almost any metal.
There are lots of jigs where you use a low powered router to finish 80% ars. Basicly you hog out for the mag and trigger group. Drill a few holes. Ak its a drill press and some rivits.
-
I expect that in the next round of gun control Bills will be something that lowers the bar for unfinished receivers. Currently an 80% is legal. I expect to see 50% as the new threshold. Anything that resembles a finished receiver. Next will be that if you purchase one of these you will be required to serialize it, with a serial number already assigned, within a certain amount of time, and at that point you will go through the NICS.