The Down Range Forum

Member Section => Handguns => Topic started by: scrappy45601 on January 26, 2011, 05:37:25 PM

Title: Ruger Sr9c
Post by: scrappy45601 on January 26, 2011, 05:37:25 PM

     I did a chop on the finger extension to where it just fits my hand.  What do you all think?


before and after

Title: Re: Ruger Sr9c
Post by: ellis4538 on January 26, 2011, 06:16:34 PM

How does it shoot?

Richard

Title: Re: Ruger Sr9c
Post by: scrappy45601 on January 26, 2011, 06:31:54 PM

     It shoots great.  Out to 10 yards is all the farther i have shot it.  The sights were dead on out of the box and i grouped 9 out of the 10 shots in a ten inch pie plate.  Not bad for first time shooting it.  Have not even loaded the 17rd mag, just got to empty the one mag behind my buddy's shop.

Title: Re: Ruger Sr9c
Post by: cookie62 on January 26, 2011, 06:36:01 PM

I did the same thing with my Glock 26 mags with Peirce 2 round extensions. They were not quite as long as the SR9, but it did make them not as noticeable under a T shirt.

Title: Re: Ruger Sr9c
Post by: scrappy45601 on January 26, 2011, 06:45:10 PM

     Yeah that tip of them sure do stick out don't they.

Title: Re: Ruger Sr9c
Post by: cookie62 on January 26, 2011, 06:50:07 PM

It also makes it a little easier to shoot. It cramed my fingers together before, now my hand fits better.

Title: Re: Ruger Sr9c
Post by: Big Frank on January 26, 2011, 06:53:01 PM

It looks good Scrappy.

Title: Re: Ruger Sr9c
Post by: scrappy45601 on January 26, 2011, 07:11:20 PM

     Thanks jumbo it didn't take long at all.  A hack saw a file and sandpaper (about ten min)

Title: Re: Ruger Sr9c
Post by: TATER SALAD on February 06, 2011, 08:01:02 PM

Great mod - if it feels better then ya did good!!

I changed back to the original flat floorplate from Pierce on my LCP for that same reason - printing...