Author Topic: Samson Quick Flip Stock  (Read 612 times)

Big Frank

  • NRA Benefactor Member
  • Top Forum Member
  • *****
  • Posts: 9743
  • DRTV Ranger
  • Liked:
  • Likes Given: 1149
Samson Quick Flip Stock
« on: November 05, 2023, 07:02:54 AM »
When I was shopping at Samson Manufacturing last week I came across their Quick Flip Stock. I think this would go great with my Dead Foot Arms folding stock adaptor. Picture that in place of one of these AR stocks. Since I was at DFA's site, I got a picture of their Bolt Carrier Modification (BCM). They do the same thing with 9mm carbine bolts too. That's why that can use a 2.5" buffer tube instead of a 4" tube with their Modified Cycle System (MCS). The KAK Industry CQC Short Pistol Buffer System uses a 5.25" buffer tube, so the 2.5" tube is quite an improvement for AR pistols too. That's what I would get if  had an AR pistol, with or without a brace. The Quick Flip Stock is Type III class 2 hard coat anodized 6061 Aluminum, with a Stainless Steel Hinge pin. It fits Commercial or MIL-SPEC Carbine buffer tubes. It's made in New Hampshire, USA, and costs $122.60.
""It may be laid down as a primary position, and the basis of our system, that every Citizen who enjoys the protection of a free Government, owes not only a proportion of his property, but even his personal services to the defence of it, and consequently that the Citizens of America (with a few legal and official exceptions) from 18 to 50 Years of Age should be borne on the Militia Rolls, provided with uniform Arms, and so far accustomed to the use of them, that the Total strength of the Country might be called forth at a Short Notice on any very interesting Emergency." - George Washington. Letter to Alexander Hamilton, Friday, May 02, 1783

THE RIGHT TO BUY WEAPONS IS THE RIGHT TO BE FREE - A. E. van Vogt, The Weapon Shops of Isher


SMF spam blocked by CleanTalk