Author Topic: Charter Arms Bulldog Range Review - Update!  (Read 34154 times)

Big Frank

  • NRA Benefactor Member
  • Top Forum Member
  • *****
  • Posts: 11223
  • DRTV Ranger
  • Liked:
  • Likes Given: 1539
Re: Charter Arms Bulldog Range review
« Reply #10 on: December 30, 2008, 09:20:15 PM »
Wheelgun, I am not picking on you but I see this a lot and it is kind of a pet peeve of mine, but all revolvers have only ONE cylinder. The five holes you load the rounds in are chambers not cylinders. One cylinder housing 5 chambers.

Not all revolvers have only one clyinder. I have a revolver with 2 cylinders in 2 different calibers. I know of a few other revolvers that have 2 or more cylinders too.
""It may be laid down as a primary position, and the basis of our system, that every Citizen who enjoys the protection of a free Government, owes not only a proportion of his property, but even his personal services to the defence of it, and consequently that the Citizens of America (with a few legal and official exceptions) from 18 to 50 Years of Age should be borne on the Militia Rolls, provided with uniform Arms, and so far accustomed to the use of them, that the Total strength of the Country might be called forth at a Short Notice on any very interesting Emergency." - George Washington. Letter to Alexander Hamilton, Friday, May 02, 1783

THE RIGHT TO BUY WEAPONS IS THE RIGHT TO BE FREE - A. E. van Vogt, The Weapon Shops of Isher

Rob10ring

  • Top Forum Member
  • *****
  • Posts: 1024
  • Liked:
  • Likes Given: 0
Re: Charter Arms Bulldog Range review
« Reply #11 on: December 30, 2008, 10:34:59 PM »
The 9mm model will chamber .380 also.  8)
I wonder if their frames are too small for a 10mm that also shoots .40. I have an Undercover, and it's pretty small and light, but I know that the do a 6-shot as well, and a .357 magnum. I'd be interested.

m25operator

  • Top Forum Member
  • *****
  • Posts: 2628
  • DRTV Ranger
  • Liked:
  • Likes Given: 0
Re: Charter Arms Bulldog Range review
« Reply #12 on: December 30, 2008, 10:46:48 PM »
Fuzdaddy, be careful what you wish for, the 10mm is too high pressure for the little guy, but if they did make it, it would be the baddest barking spider you ever held ;) but I am now looking at charter even more, the .45acp bulldog will be a beast, probably need one. I have a 3" S&W 625 and its all stainless steel, and its a little beastie, better now with rubber grips.
" The Pact, to defend, if not TO AVENGE '  Tarna the Tarachian.

Big Frank

  • NRA Benefactor Member
  • Top Forum Member
  • *****
  • Posts: 11223
  • DRTV Ranger
  • Liked:
  • Likes Given: 1539
Re: Charter Arms Bulldog Range review
« Reply #13 on: December 30, 2008, 10:59:31 PM »
Anyone know how .45 ACP compares to .44 Special in a snubbie? I think .45 +P would be pretty good.
""It may be laid down as a primary position, and the basis of our system, that every Citizen who enjoys the protection of a free Government, owes not only a proportion of his property, but even his personal services to the defence of it, and consequently that the Citizens of America (with a few legal and official exceptions) from 18 to 50 Years of Age should be borne on the Militia Rolls, provided with uniform Arms, and so far accustomed to the use of them, that the Total strength of the Country might be called forth at a Short Notice on any very interesting Emergency." - George Washington. Letter to Alexander Hamilton, Friday, May 02, 1783

THE RIGHT TO BUY WEAPONS IS THE RIGHT TO BE FREE - A. E. van Vogt, The Weapon Shops of Isher

Rob10ring

  • Top Forum Member
  • *****
  • Posts: 1024
  • Liked:
  • Likes Given: 0
Re: Charter Arms Bulldog Range review
« Reply #14 on: December 31, 2008, 04:01:37 PM »
Fuzdaddy, be careful what you wish for, the 10mm is too high pressure for the little guy, but if they did make it, it would be the baddest barking spider you ever held ;) but I am now looking at charter even more, the .45acp bulldog will be a beast, probably need one. I have a 3" S&W 625 and its all stainless steel, and its a little beastie, better now with rubber grips.
I figured that a Charter in 10mm would need a little more metal. I have a 3 inch ported 629. The Hogue grips on it are the type that don't cover the backstrap, and that is one punishing beast. It's been known to take a little skin.

Sponsor

  • Guest
Re: Charter Arms Bulldog Range Review - Update!
« Reply #15 on: Today at 07:42:06 AM »

MikeBjerum

  • Top Forum Member
  • *****
  • Posts: 10991
  • DRTV Ranger
  • Liked:
  • Likes Given: 1133
Re: Charter Arms Bulldog Range review
« Reply #15 on: January 01, 2009, 08:20:28 AM »
I've got to start a reference sheet ...

Clip = Haz
Cylinder = Lonedog
Woman Bashing = M'ette
Hitting on M'ette = Marshal
JumboFrank = Fear of showers (group in particular)
If I appear taller than other men it is because I am standing on the shoulders of others.

Big Frank

  • NRA Benefactor Member
  • Top Forum Member
  • *****
  • Posts: 11223
  • DRTV Ranger
  • Liked:
  • Likes Given: 1539
Re: Charter Arms Bulldog Range review
« Reply #16 on: January 01, 2009, 08:29:40 AM »
I've got to start a reference sheet ...

Clip = Haz
Cylinder = Lonedog
Woman Bashing = M'ette
Hitting on M'ette = Marshal
JumboFrank = Fear of showers (group in particular)

LOL. That's a good one. I haven't showered since last year. When there are 6 showers and 12 guys you would think everyone would just take turns. But when the guards turn the water off after 5 minutes it's different. At least in the cellblock we didn't have to yell down the hallway for a guard to flush the toilet by remote control like in the individual cells. I don't ever plan on going to prison again. I wasn't actually planning on it that time either. Sometimes unexpected things happen when I drink.
""It may be laid down as a primary position, and the basis of our system, that every Citizen who enjoys the protection of a free Government, owes not only a proportion of his property, but even his personal services to the defence of it, and consequently that the Citizens of America (with a few legal and official exceptions) from 18 to 50 Years of Age should be borne on the Militia Rolls, provided with uniform Arms, and so far accustomed to the use of them, that the Total strength of the Country might be called forth at a Short Notice on any very interesting Emergency." - George Washington. Letter to Alexander Hamilton, Friday, May 02, 1783

THE RIGHT TO BUY WEAPONS IS THE RIGHT TO BE FREE - A. E. van Vogt, The Weapon Shops of Isher

justbill

  • Very Active Forum Member
  • ****
  • Posts: 142
  • Liked:
  • Likes Given: 0
Re: Charter Arms Bulldog Range review
« Reply #17 on: January 01, 2009, 02:15:42 PM »
Charter's new revolver for rimless cartridges is pretty interesting.

http://www.gunpundit.com/1487.php


Let's just see if it works. Charter and I go way back and I've never been satisfied with any of their products. If they truly can get a 100% reliable and decently accurate 12 oz. 9mm, I'll buy one for certain. That would make for a great left pocket piece.

PegLeg45

  • NRA Life, SAF, Constitutionalist
  • Top Forum Member
  • *****
  • Posts: 13265
  • DRTV Ranger
  • Liked:
  • Likes Given: 1363
Re: Charter Arms Bulldog Range review
« Reply #18 on: January 01, 2009, 03:02:47 PM »
Wheelgun, I am not picking on you but I see this a lot and it is kind of a pet peeve of mine, but all revolvers have only ONE cylinder. The five holes you load the rounds in are chambers not cylinders. One cylinder housing 5 chambers.


Well, technically, based on the definition of a cylinder, the chambers are cylinders too. Just like the cylinders in an engine block.


n.
   1. Mathematics.
         1. The surface generated by a straight line intersecting and moving along a closed plane curve, the directrix, while remaining parallel to a fixed straight line that is not on or parallel to the plane of the directrix.
         2. The portion of such a surface bounded by two parallel planes and the regions of the planes bounded by the surface.
         3. A solid bounded by two parallel planes and such a surface, especially such a surface having a circle as its directrix.
   2. A cylindrical container or object.
   3. Engineering.
         1. The chamber in which a piston of a reciprocating engine moves.
         2. The chamber of a pump from which fluid is expelled by a piston.
   4. The rotating chamber of a revolver that holds the cartridges.
   5. Any of several rotating parts in a printing press, especially one that carries the paper.
   6. Archaeology. A cylindrical stone or clay object with an engraved design or inscription.


A cylinder is one of the most basic curvilinear geometric shapes: the surface formed by the points at a fixed distance from a given straight line, the axis of the cylinder. The solid enclosed by this surface and by two planes perpendicular to the axis is also called a cylinder. The surface area and the volume of a cylinder have been known since deep antiquity.

In firearms terminology, the Cylinder refers to the cylindrical, rotating part of a revolver containing multiple cartridge chambers. The cylinder revolves around a central axis in the revolver to bring each individual chamber into alignment with the barrel for firing. Each time the gun is cocked, the cylinder indexes by one chamber (in six-shooters, 60°).


So, in essence, relating to revolvers, the chambers are cylinders within a cylinder.   ;)
 

All in good fun.
Welcome aboard.

 ;D
"I expect perdition, I always have. I keep this building at my back, and several guns handy, in case perdition arrives in a form that's susceptible to bullets. I expect it will come in the disease form, though. I'm susceptible to diseases, and you can't shoot a damned disease." ~ Judge Roy Bean, Streets of Laredo

For the Patriots of this country, the Constitution is second only to the Bible for most. For those who love this country, but do not share my personal beliefs, it is their Bible. To them nothing comes before the Constitution of these United States of America. For this we are all labeled potential terrorists. ~ Dean Garrison

"When it comes to the enemy, just because they ain't pullin' a trigger, doesn't mean they ain't totin' ammo for those that are."~PegLeg

2HOW

  • Top Forum Member
  • *****
  • Posts: 1861
  • Liked:
  • Likes Given: 0
Re: Charter Arms Bulldog Range review
« Reply #19 on: January 01, 2009, 03:38:37 PM »
I like charter arms had a bulldog pug in .44 spl very nice, sorry I sold it.
AN ARMED SOCIETY IS A POLITE SOCIETY

 

SMF spam blocked by CleanTalk