Ultimate gun lube?!?

[Badgersmilk]

http://www.tacticalgunfan.com/index.php?option=com_content&task=view&id=341&Itemid=1

Red Oil Recipe
3 quarts ATF (red F-type)
1 quart 10W non-detergent motor oil
1 pint STP oil treatment
4 ounces Hoppe's No. 9

[2HOW]

Im sure all thats fine stuff. I have never used anything but breakfree CLP in my life and wont stop now. Its absolutley the best cleaner, lubricant and protectant on the market. IMO if you need some super lube to make your guns run , there is a problem with the gun. just my .02

[tombogan03884]

 That's a nice recipe for a gallon of lube, however I have a pint bottle of CLP that has lasted 3 years so far.

[Badgersmilk]

I actually use one of four different lubes / grease's depending on the gun, and where its being applied on the gun.  This concoction's intrieging though...  

[2HOW]

That's a nice recipe for a gallon of lube, however I have a pint bottle of CLP that has lasted 3 years so far.

DID we just agree? OMG ! 

[Sponsor]

[tombogan03884]

Mark it on the Calendar 

[Badgersmilk]

Am I wrong thinking CLP is a penetrant, and leaves teflon on surfaces?  I wont say anymore.  Just curious.

[tombogan03884]

 Yes, it was formulated for AR's. HOWEVER if it gets cold (below 45 degrees) the teflon will seperate out, if that happens you have to take a hair dryer and heat the stuff to around 90 degrees to remix it.

[Woody]

I clean with WD-40, or Ed's Red's cleaner, armed with a Sonicare and re-oil with Hoppes MPro-7, or Ultima lube by Wilson Combat. I'll have to try that recipe.

[2HOW]

Am I wrong thinking CLP is a penetrant, and leaves teflon on surfaces?  I wont say anymore.  Just curious.

Its my experience that it soaks into the metal, This can be seen when the gun gets hot from shooting and it weaps from the metal. I soak every new gun for 24 hrs  (heavy spray) . then wipe off, shoot and lightly clean with same.