Very nice! The dot shows up well!
Thanks Haz,
There is not much more I can do with it now, unless I can find a way of importing a pac-lite upper and barrel, its already cost me enough at moment, I am thinking I might just shoot the hell out of it as it is LOL
When I installed the trigger kit I gave the bolt a good work over too, was rubbing a little in places, I placed some blue texta on te bolt and slid it in and out a few times to see where it marked on the bolt and then gave it a little clean up with some 300gr wet and dry, tried it again and done the same. Later that night when i had time I stepped the paper up to 600 grit and gave a light over all clean up and then polished it with magquires stainless steel polish and buffing wheel on the dremel, came up nice and shiny and slicker than snot! No more rub marks and cycles like its on bearings.
Just need some more times to run it in, put through 200rnds the other day and only misfire I had was caused by me having the pretravel screw wound down too much. After that was a little ripper to shoot.
MBTV
Forum Index
Help
Calendar
Contact Info
Register as a member
